Surgex SX-20NE-RT-AR User Manual download pdf

SX-20NE-RT-AR Quick Start Guide Page 1

Connections

1. Connect Network. The SX-20NE-RT-AR supports 10/100 Ethernet using

the cable supplied, or other suitable unshielded twisted pair (Cat 5) cabling.

2. Connect Powered Equipment. Connect the wires to the equipment (load)

to be powered On and Off to the lower terminal block labeled “Load”. Connect

Black to Load, White to Neutral, and Ground to Ground. If the connected

equipment has a Power switch, leave it in the On position to allow the SX-

20NE-RT-AR to control the power.

3. Connect Power Mains. Connect the wires from the electrical service (line)

to the upper terminal block labeled “Line”. Connect Black to Line, White to

Neutral, and Ground to Ground.

IMPORTANT: In order for the SurgeX circuitry to function properly, the unit

must be installed exactly as stated above (the unit will not function without a

Neutral connection).

The SurgeX SX-20NE-RT-AR product is rated at a load capacity of 20 Amps

and shall be wired only by qualified Electricians using 12 Ga. conductors as

specified in Article 310 of the 1999 National Electric Code, as set forth in

Table 310-13. Any type of conductor suitable for use in wet or dry locations

such as (but not limited to) THHN, THHW, THW, THWN, or TW shall be

considered acceptable if local Code permits. The circuit to which the product

is connected must be protected by a 20 Amp circuit breaker.

Web Browser Access

Factory Default IP Address: 192.168.1.254

Factory Default Security

Credentials:

To access the SX-20NE-RT-AR from the default IP Address, the PC must be on the same local network

(IP address of 192.168.1.nnn). If it is not, change the IP address using one of the methods on the

following page.

After pointing a web browser to the IP address of the SX-20NE-RT-AR, enter the Administrator Username

and Password to access the complete Setup features. Entering the User credentials will enable access to

only the power control. Once the user is validated, the Control and Status page is displayed.

Click on the appropriate button to control the power. During power cycling, the Power Status bar will

indicate the temporary status, and will

have a blue background. Once the cycle is

complete, the status bar will revert to its

original condition.

Role

Username

Password

Administrator

admin

User

user

1 2

Connections 1
Changing the IP Address 2

Summary of Contents

Page 1 - Connections

SX-20NE-RT-AR Quick Start Guide Page 1 Connections 1. Connect Network. The S

Page 2 - Changing the IP Address

SX-20NE-RT-AR Quick Start Guide Page 2 Changing the IP Address 1. Device

Surgex SX-20NE-RT-AR User Manual

Browse online or download User Manual for Computer Accessories Surgex SX-20NE-RT-AR. SurgeX SX-20NE-RT-AR User Manual

Summary of Contents

More documents for Computer Accessories SurgeX SX-20NE-RT-AR

Comments to this Manuals

Surgex SX-20NE-RT-AR User Manual

Browse online or download User Manual for Computer Accessories Surgex SX-20NE-RT-AR. SurgeX SX-20NE-RT-AR User Manual

Summary of Contents

More documents for Computer Accessories SurgeX SX-20NE-RT-AR

Comments to this Manuals

Related products and manuals for Computer Accessories Surgex SX-20NE-RT-AR