Surgex SX-AX20 User Manual download pdf (Page 2)

Axess Quick Start Guide Page 2

Changing the IP Address

1. Command Line Interface (CLI).

All configuration parameters may be set using the

Command Line Interface (CLI). The CLI is accessed

through the network using a telnet client, or through the

serial port.

Open a telnet client and point it to the current IP

Address of the Axess.

(Factory Default is 192.168.0.254, telnet Port 23)

Connect to the Serial port.

(Factory Default is 115200,8,n,1)

Upon connection, press Enter, and then enter the

username and password when prompted.

The example shows the basic commands to set the

network parameters. After setting these parameters, the

Axess will need to be rebooted for the settings to take

effect. Any command that requires rebooting of the

Axess will provide a prompt to do so. All commands

may be entered as required before rebooting. Once the

IP address is set, the following command can be used to prevent DHCP from altering it:

set ipmode static

2. DHCP

A DHCP server will automatically assign an IP address (dynamic address) as well as

Subnet Mask and Gateway to the Axess.

To enable this feature, configure the Axess with the command set ipmode dhcp

Then reboot the Axess by entering the command reboot

To find the IP address of the Axess, you will need to query your DHCP server and

locate the MAC address of the Axess in the DHCP server’s IP / MAC table. You can

also access the CLI and use the get network command, or use the Discover provision

of the Axess Setup and Control Utility (SCU).

1 2 3

No comments

Surgex SX-AX20 User Manual Page 2