Surgex SX-AX20 User Manual download pdf (Page 31)

SX-AX15 (20) User Manual

Page 30

IX. SNMP

X. Firmware Upgrades

XI. Front Panel Reset Button

Up to four SNMP managers can be set. Each manager will receive Trap notifications for outlet

changes, autoping, voltage alarms, and current alarms. Set the SNMP manager IP addresses

using the set snmp <n> ipaddress <dotted decimal> command. Enable or Disable SNMP for

any manager with the set snmp <n> enable <yes | no> command.

The Axess MIB is available at surgex.com.

Syslog

The Axess contains a built in Syslog client. When enabled, it will send Syslog formatted UDP

messages on port 514.

Messages will be sent for the following:

• Outlet Changes

• AutoPing Triggers

• High Voltage Alarm

• Low Voltage Alarm

• High Current Alarm

• Low Current Alarm

Example:

08-02-2012 16:18:16 User.Info 10.1.2.5 Aug 2, 2012 16:18:15 Axess 1 Outlet1 Off admin Console

The Axess can be upgraded via the network if the upload feature has been enabled using the

set upload enable yes command on the console interface. To upgrade the Axess, download

the latest versions of the firmware and upgrade utility from surgex.com.

The recessed reset pushbutton located on the front panel below the Self Test LED performs two

functions: CPU Reboot and Password Reset.

Pressing the reset button once quickly will reboot the Axess. Outlet states are not affected.

Holding the reset button on the front panel of the Axess for 5 seconds or longer will initiate a

password recovery mode. Once the reset button is released, the user has 30 seconds to log in

to the CLI using the username admin and password admin. Upon accessing the CLI, change

the usernames and passwords as desired.

1 2 ... 26 27 28 29 30 31 32 33 34

No comments

Surgex SX-AX20 User Manual Page 31