Surgex SX-20NE-RT-AR User Manual download pdf (Page 11)

SX-20NE-RT-AR User Manual

Page 10

V. Initial Set-Up

(continued)

Setting the IP Address

ARs are configured with a factory default IP address of 192.168.1.254.

To set the AR’s IP address using one of the following methods, the computer and AR must be

on the same local network.

DMU: Follow the steps in the preceding subsection to set the IP address using the Device

Management Utility (DMU).

CLI: These are the basic commands to set the network parameters. After setting these

parameters, the AR will need to be rebooted for the settings to take effect. Any command that

requires rebooting of the AR will provide a prompt to do so. All commands may be entered as

required before rebooting. Manually specifying the IP address via CLI automatically sets the

address as static.

Example: Telnet to default IP address of 192.168.1.254 on default Port 23:

SurgeX Axess Ready v1.01.41

User> admin

Password> *****

Axess Ready> set ipaddress 10.1.2.69

Axess Ready Reboot Required> set subnet 255.255.255.0

Axess Ready Reboot Required> set gateway 10.1.2.1

Axess Ready Reboot Required> reboot

The CLI command set ipmode dhcp followed by a reboot command may be used to configure

the AR to automatically acquire its network settings from a DHCP server. A DHCP server will

automatically assign an IP address (dynamic address), as well as the Subnet Mask and

Gateway.

To determine what IP address has been automatically assigned by the DHCP server, you will

need to use the Discover feature of the DMU or query your DHCP server and locate the MAC

address of the AR in the DHCP server’s IP/MAC table.

Web: To set the IP address using a web browser, navigate to the current IP address of the AR

(192.168.1.254 if the unit is in a factory default state). Enter the administrator credentials

(Factory Default User: admin, Password: admin), click on “Setup”, then click on “Network” and

follow the directions in the Web Server/Network/Setup section of this manual.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

No comments

Surgex SX-20NE-RT-AR User Manual Page 11