SX-20NE-RT-AR User Manual
VII. Command Line Interface (CLI) Protocol
The Command Line Interface provides complete setup of all functions of the AR. The CLI may be accessed through the Telnet
protocol, and requires a Telnet client program. Some commands of the CLI require administrative rights; these are indicated in the
following tables.
Prompts
Prompts the user to enter the user name (either user or admin).
Prompts the user to enter the password.
Prompt displayed while logged in.
Axess Ready Reboot Required>
Prompt displayed after changes have been made that require a reboot. This
prompt will remain active until the AR has been rebooted.
Control Commands
Returns the current status of the outlet.
set outlet < on | off | cycle >
Sets the outlet to the selected state.
Device Commands
set location < 20 character max >
Returns the cycle time currently in use in seconds.
Sets the cycle time in seconds.
Returns the upgrade enable status.
set upgrade enable < yes | no >
Enables or disables the ability to upload new
firmware.
Terminates the telnet session.
Comments to this Manuals